Tag Archives: diy jewelry

DIY Sliding Knot Bracelet

This awesome tutorial was brought to you by Honestly WTF

You’ll Need

Thread 4 inches of cord through one side of the charm. Fold 2 inches of cord back on itself and then again to create a zig zag.

Fold an inch of the tip down over the parallel cords. Coil the cord three times towards the loop.

Thread the tip through the opening of the left loop.

Push the coil to the left and pull the tip until the knot is tight. Test the adjustable knot by sliding it towards the base of the charm. The excess cord will be trimmed later.

Thread the other end of the cord through the opposite side of the charm and create the same zig zag.

Coil the tip around all the cords three times and thread the tip through the loop.

Push the coil to the left and pull the tip until the knot is tight. Trim both ends, leaving approximately 2-3mm.

Melt the ends with a lighter.

Your bracelet is finished . . .

For more great diy ideas make sure to check honestlywtf.com.

Tagged , ,

DIY Utility Rope Necklace

This awesome tutorial was brought to you by Honestly WTF

You’ll need:

  • 25 feet of 3mm utility rope 
  • 12 – 14 pieces of 3/8″ brass compression sleeves
  • 3-5 yards of 0.8-1mm chinese knotting cord
  • 2 12mm x 16mm cord end caps
  • 2-3 jump rings
  • 1 lobster clasp lobster clasp
  • gel super glue
  • scissors
  • pliers

Start by cutting the utility rope into 8 32 inch pieces. Gather them together and slide the compression sleeves on, one at a time.

Keeping the compression sleeves together keep the ropes evenly bound and make sliding them on easier. After 12-14 sleeves are on the ropes, spread them out accordingly.

Decide which sections to wrap and start at the center of the necklace. Run the end of the knotting cord upwards along one section and towards the edge of a brass sleeve. Then wrap around the ropes, working downwards in the opposite direction. This helps secures the cord.

continue to wrap the entire section. Before reaching the end of the section, place a bead of glue along the starter cord and finish wrapping.

Allow to dry before trimming any excess cord. Continue wrapping different sections of the necklace.

When all the sections have been wrapped, trim end ends. Squeeze a generous amount of glue into the cap and insert the end of the necklace into it. It may require some rotating to get the end of the necklace into the cap. Repeat the step on the other end.

Using pliers, attach a larger jump ring to one end and a clasp to the other.

And that’s it, your necklace is finished!

Make sure to check out Honestly Wtf for more great diy ideas.

Tagged , ,