DIY Sliding Knot Bracelet

This awesome tutorial was brought to you by Honestly WTF

You’ll Need

Thread 4 inches of cord through one side of the charm. Fold 2 inches of cord back on itself and then again to create a zig zag.

Fold an inch of the tip down over the parallel cords. Coil the cord three times towards the loop.

Thread the tip through the opening of the left loop.

Push the coil to the left and pull the tip until the knot is tight. Test the adjustable knot by sliding it towards the base of the charm. The excess cord will be trimmed later.

Thread the other end of the cord through the opposite side of the charm and create the same zig zag.

Coil the tip around all the cords three times and thread the tip through the loop.

Push the coil to the left and pull the tip until the knot is tight. Trim both ends, leaving approximately 2-3mm.

Melt the ends with a lighter.

Your bracelet is finished . . .

For more great diy ideas make sure to check honestlywtf.com.

Advertisements
Tagged , ,

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: